3Com 3CR990-TX-95, 3CR990-TX-97, 3CR990SVR97, 3CR990SVR95 manual Windows NT, Click Next, Click Finish

Installing the Network Driver Using the EtherCD 41

3Click Next.

The Install Hardware Device Drivers screen appears.

4Insert the EtherCD in the CD-ROM drive.

5Select Search for a suitable driver for my device (recommended), and then click Next.

The Locate Driver Files screen appears.

6Select the CD-ROM drives option, clear any other checked options, and click Next.

The Driver Files Search Results screen appears. Windows finds the driver on the EtherCD.

7Click Next.

The Hardware Install screen appears. Files are copied. Then the Complete the Found New Hardware Wizard screen appears, displaying the message “Windows has finished installing the software for this device.”

8Click Finish.

The software installation is complete. Go to Verifying Successful Installation on page 48 to confirm that the NIC is properly installed.

To change configuration settings, see Configuring the NIC on page 113.

Windows NT 4.0

This section describes how to install the network driver and NIC software in a PC or server running Windows NT 4.0

.

CAUTION: Windows NT 4.0 Service Pack 6 (SP6) is a minimum system requirement for installing 3Com DynamicAccess technology.

To install the network driver:

1Turn on the power to the PC and start Windows NT.

2Log in to the Windows NT Administrator account.

3Insert the EtherCD in the CD-ROM drive.

4Right-click the Network Neighborhood icon.