3Com 3CR990SVR95, 3CR990-TX-97, 3CR990-TX-95 Click Yes to restart the PC, Turn the PC power on

Installing the Network Driver Using the EtherCD 43

Refer to your system administrator or the Windows NT documentation for assistance. After entering the appropriate TCP/IP information and clicking OK, the Network Settings Change window appears.

If the Microsoft TCP/IP Properties screen does not appear, the installation is complete. The Network Settings Change window appears.

14Click Yes to restart the PC.

The network driver installation is complete. Go to Verifying Successful Installation on page 48 to confirm that the NIC is properly installed.

Windows 98

This section describes how to install the network driver and NIC software in a PC or server running Windows 98.

Before installing the NIC software:

■Make sure that the NIC is installed in the PC and connected to the network.

■Make sure that you have the Windows 98 installation files. These files may be on a CD or diskettes, or they may have been copied to your hard disk when Windows 98 was installed on your PC.

If you encounter problems during the installation, see TROUBLE.TXT (located in the HELP directory on the EtherCD) for troubleshooting tips.

To install the software:

1Turn the PC power on.

Windows detects the NIC. The Add New Hardware Wizard starts.

2Click Next.

The Add New Hardware Wizard screen prompts you to select an option.

3Select the Search for the best driver for your device (Recommended) option, and then click Next.

The Add New Hardware Wizard screen prompts you for the driver location.