3Com 3CR990-TX-95, 3CR990-TX-97, 3CR990SVR97, 3CR990SVR95 manual Help, Link timeout, Probe interval

Syntax

Example

Maintaining Groups 109

lbrsl display status [pri_slot]

where:

pri_slot is the PCI slot number of the primary NIC in the group for which information is to be displayed. If this parameter is not specified, information for all groups is displayed. An example of the type of information displayed follows:

Group NNN (LB group)

Primary board id: Original NNN, Current NNN

Load balancing on incoming IP packets: Enabled; IP Rx

Addr: NN.NN.NN.NN

Primary node address: XX:XX:XX:XX:XX:XX

Timeout values in seconds: send NNN, receive NNN, wait NNN, link NNN

Probe Interval: NNN seconds

Slot number NNN (Active), Node Address: XXX:XXX:XXX:XXX:XXX:XXX

lbrsl display status 10001

help

This command displays the syntax for the DynamicAccess server features commands.

Syntax lbrsl help

link timeout

When a group is being created, the software waits the number of seconds specified by this command for the link/topology check to finish and then displays timeout information.

Syntax lbrsl link timeout seconds

where:

seconds is the time in seconds.

Example lbrsl link timeout 10

Default 5

probe interval

This command sets the probe packet interval. If no argument is specified or the specified argument is invalid, the current value is displayed. Otherwise, the new value is displayed.