3Com 5104M-FL1 Showing Module Configuration, Saving Module Configuration

To enable RFS for a port, issue the following management command:

SET PORT {slot.port} MODE REMOTE_FAILURE_SIGNALING

Saving Module Configuration

To save the module and port settings to management module memory, issue the following command:

SAVE MODULE_PORT

Showing Module Configuration

You can display status information about the 10BASE-FL Module using the following commands:

❑SHOW MODULE

❑SHOW MODULE VERBOSE

❑SHOW PORT

❑SHOW PORT VERBOSE

For example, the following command displays detailed information about port 1 on an 10BASE-FL Module in slot 6 of the concentrator.

ONline> show port 6.1 verbose			[ENTER]
Port Display for Module 5104M-FL
Port	Mode	Status	Network	General Information
06.01	ENABLED	OKAY	ISOLATED
Port Connector			FIBER
Mode Dip Setting:			ENABLED

3 - 16 ONline Ethernet 10BASE-FL Installation and Operation Guide