3-12 CHAPTER 3: ROUTING IP
It is important to enter static routes when configuring the unit to use unnumbered links because these routes will not be learned by the unit. Static routes must be entered at both ends of the link.
Set up the IP Routing table to associate an IP route with a unit name.
1Enter CO RO IP to display the Configured IP Routes screen.
2Enter ADD to display the Add Routing Table Entry screen.
3Type the IP address of the remote LAN in the Target field.
4Type a valid subnet mask for the remote network in the Subnet Mask field.
5Type the name of the remote unit in the Router field.
Unit names are
6Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Establish a Remote Management Session
A manual call must be placed before the remote configuration of the remote unit can proceed.
1Enter CO IS NU to display the ISDN Numbers table.
2Select the entry for the remote unit using the Arrow keys and enter
CALL
3Enter REM to display the Remote Units screen. Refresh the screen by pressing [Ctrl]+[D] at regular intervals until an entry for NoName appears.
4Select the NoName 10.0.0.1 entry using the Arrow keys and enter
REM
5The Enter Password screen of the remote unit should be displayed within 30 seconds.
■If the Enter Password screen is not displayed, check that the name and IP address for the remote unit have been entered correctly on the central site unit and that the ISDN line is connected and working normally at both ends of the link.
6Enter PASSWORD (in
