Configuring a Remote Unit from the Central Site |
Configure the ISDN Numbers Table on the Central Site Unit
Set up the ISDN numbers table to associate the name which the remote unit will have once it has been configured, with the ISDN number.
1Enter CO IS NU to display the ISDN Numbers screen.
2Enter ADD to add a new entry to the numbers table.
3Type the name that the remote unit will have in the Name field.
4Type the ISDN number for the remote unit in the ISDN Number 1 field.
It is very important to remember that Novell IPX routing uses numbered links. This means that the ISDN line between this unit and a remote site represents an additional Novell IPX network and has to be assigned a valid Novell IPX network number.
5Type the IPX network address of the numbered link in the IPX Network field, not the IPX network address of the remote unit.
6Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Establish a Remote Management Session
A manual call must be placed before the remote configuration of the remote unit can proceed.
1Enter CO IS NU to display the ISDN Numbers table.
2Highlight the entry for the remote unit and enter CALL
3Enter REM to display the Remote Units screen. Press [Ctrl]+[V] at regular intervals to refresh the screen, until an entry for NoName 10.0.0.1 appears.
4Select the NoName 10.0.0.1 entry using the Arrow keys and enter
REM
5The Enter Password screen on the remote unit should be displayed within 30 seconds.
■If the Enter Password screen is not displayed, check that the name and IP address for the remote unit have been entered correctly on the central site unit and that the ISDN line is connected and working normally at both ends of the link.
