Configuring a Remote Unit from the Central Site |
3Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Configure the Ethernet Port
Changing the IP address during the remote management session causes the session to be disconnected when the new IP address is submitted. This is normal.
1Enter CO PO to display the Port Configuration screen.
2Select the LAN1 port using the Arrow keys and enter ED to display the Edit Ethernet Port screen.
3Type the IP address assigned to the unit in the Port IP Address field. The IP address must be exactly the same as that used to configure the central site unit ISDN Autocall table.
4Press [Ctrl]+[E] to submit the new setting.
Submitting the new settings causes the remote management session to disconnect immediately.
5Press [Ctrl]+[D] to return to the central site unit management screens.
6Enter REM to display the Remote Units screen and press [Ctrl]+[V] to refresh the screen.
7Select the entry for the remote unit using the Arrow keys. Note that the entry now contains the remote unit name and IP address.
8Enter REM to establish a new remote management session.
9Enter PASSWORD at the Enter Password screen.
10Save the new configuration by entering SAVE
Configure the ISDN Numbers Table
Set up the ISDN numbers table to associate the central site unit name with its ISDN number.
1Enter CO IS NU to display the ISDN Numbers screen.
2Enter ADD to add an entry to the ISDN Numbers table.
3Type the name assigned to the central site unit in the Name field and the ISDN number for that unit in the ISDN Number 1 field.
Unit names are
