3Com 980-000077/002 manual Configuring the Remote Site Unit, Establish a Remote Management Session

2-10CHAPTER 2: BRIDGING AND IP

3Type the name assigned to the remote unit in the Remote Unit field.

Unit names are case-sensitive and must be entered correctly.

4Type the IP address assigned to the remote unit in the IP Address field.

5Press [Ctrl]+[E] to submit the new setting and then enter SAVE

Establish a Remote Management Session

A manual call must be placed before the remote configuration of the remote unit can proceed.

1Enter CO IS NU to display the ISDN Numbers table.

2Select the entry for the remote unit using the Arrow keys and enter

CALL

3Enter REM to display the Remote Units screen. Press [Ctrl]+[V] at regular intervals to refresh the screen, until an entry for NoName 10.0.0.1 appears.

4Select the NoName 10.0.0.1 entry using the Arrow keys and enter

REM

5The Enter Password screen on the remote unit should be displayed within 30 seconds.

■ If the Enter Password screen is not displayed, check that the name and IP address for the remote unit have been entered correctly on the central site unit and that the ISDN line is connected and working normally at both ends of the link.

6Enter PASSWORD (in upper-case letters) when the Enter Password screen is displayed.

Configuring the Remote Site Unit

Assign the Unit Name

1Enter CO SYS to display the System Parameters screen.

2Type in the name assigned to the unit in the Unit Name field. The name must be exactly the same as that used to configure the entry for this unit in the central site unit ISDN Numbers table.