216 CHAPTER 3: DEVICE CONFIGURATION
Configuring the
BRI-ST Digital Line
Card
These sections tell you how to use the NBX NetSet utility to set up your
BRI-ST Digital Line Card parameters:
■Configuring for ISDN BRI Signaling
■Configuring BRI Groups
■Verifying BRI Group Membership
■Completing the BRI-ST Configuration
Before you configure the BRI-ST card, you must configure the Dial Plan as
described in Chapter 2.
Configuring for ISDN BRI Signaling
CAUTION: Before you begin to configure the BRI-ST card, be sure to wait
3 minutes after you insert the BRI-ST card into the chassis.
To configure for ISDN BRI signaling:
1Select NBX NetSet > Device Configuration > Digital Line Cards.
2In the T1/ISDN Board List, find the MAC address of the BRI-ST board that
you recorded before you inserted the card into the chassis.
3Select the BRI-ST card from the list and click Modify.
4Scroll through the Channel List to verify that the system lists all eight
channels. The channel numbers appear after the MAC address, separated
by a hyphen.
Example:
2...00:01:03:48:e0:4e-4...New Trunk.
The 4 after the hyphen indicates channel number 4.
5To change the name of the BRI-ST card, edit the contents of the Board
Name field to help you to identify the BRI-ST card in device lists.
6Enable the On Line check box.
7Click OK.
To connect the BRI line and activate the span:
1Plug the BRI line into the BRI interface box.
2Using a category 5 Ethernet cable, connect the BRI interface box to one
of the four ports on the front panel of the BRI-ST card.