228 CHAPTER 3: DEVICE CONFIGURATION
If the DDI/DID numbers match your internal extension numbers, the
translator entries in your Dial Plan configuration file can be much simpler.
Example: You plan to use internal extensions from 100 through 299,
and the local telephone company assigns you numbers from
617-555-4100 through 617-555-4299. If the local telephone carrier
passes you three digits, you need no translator entries in the Dial Plan
configuration file. If the carrier passes you four digits, you could add a
single set of translator entries to the configuration file to remove the first
digit (4) and use the remaining three digits as the internal extension.
Enabling Auto Discovery for Digital Line Cards
To enable Auto Discovery for Digital Line Cards:
1Select NBX NetSet > System Configuration > System Settings >
System-wide.
2Enable the Auto Discover Digital Line Cards check box.
Other check boxes may be selected based upon previous
Auto Discoveries. You do not need to clear these check boxes to install
the E1 card.
3Click OK.
Inserting the E1 Digital Line Card
You do not need to remove the power cable from the chassis before you
insert the E1 card.
To insert the E1 Digital Line Card into the chassis:
1Write down the MAC address of the E1 card.
2Select a slot for the E1 card in the chassis, and use a Phillips screwdriver
to remove the blank faceplate from the slot.
3Insert the E1 card into the slot.
4Slide the E1 card into the chassis until you feel it touch the connectors.
5To seat the E1 card into the connectors, press the front of the card firmly.