Connecting and Managing Analog Devices 207
5To optionally send a status message to the Call Processor about the ATA
or ATC port, select Device Refresh and click Apply.
6To optionally reset the ATA or ATC port, select Reset Device and click
Apply. A dialog box prompts you to confirm the reset.
7Click Yes. The ATA or ATC port resets itself.
CAUTION: On the 3C10114 Analog Terminal Card, you can reboot
individual ports without affecting the other ports. However, if you reboot
a port on the 3C10114C Analog Terminal Card, all four ports on the card
are rebooted. Active calls on any of these ports are disrupted.
8Click OK.
Advanced Settings You can set the audio gain and timing controls on each port of an Analog
Terminal Card, or on an Analog Terminal Adapter. To set these
parameters:
1Select NBX NetSet > Device Configuration > ATA.
2Select one of the ports in the list and click Advanced Settings.
If you change any of the values in the Advanced Settings dialog box, the
settings you change persist if you later upgrade the NBX system software
or you change the regional software.
Reset Device Reboots the ATA or ATC port. The ATA or ATC port
renews communications with the Call Processor and
receives a new download of its operating software.
Time Last Seen The time when the ATA or ATC port last communicated
to the Call Processor.
Error Count
Error Code
Performance Data
Debug Data
Actor Data
Advanced diagnostic data for use by technical support
personnel.
Table40 Device Status Fields (continued)
Field Purpose