Configuring and Managing BRI-ST Digital Line Cards 219
Modifying a
BRI-ST Card
These sections tell you how to modify a BRI card that is already installed in
the system:
■Modifying a BRI Span
■Modifying Audio Controls
For the BRI-ST card, you can modify only a BRI span. You cannot modify
the board type for a BRI-ST card.
Modifying a BRI Span
To modify a span:
1On the Digital Line Cards tab, from the Select Device Type drop-down list,
select ISDN BRI Span List and then click Apply.
2Select the span you want to modify from the Span List. Click Modify. The
Modify Span dialog box appears.
3Make the changes that you want. Tab le 43 lists all span parameters. The
ISDN BRI-ST Digital Line Card supports two channels per span.
4Click Apply.
5Enable the On Line check box to bring the span online. Note that the
span does not come online unless the card is online first.
6Click Apply to make the changes and then click OK.
Table43 Span Parameters
Parameter ISDN BRI Options
Span Name A name that helps you identify this span in span
lists.
Interface Type N/A
CO Switch Protocol ETSI
Framing Type N/A
Line Code N/A
Line Length N/A
Timing Mode N/A
Terminal Endpoint Identifier
(TEI) Enter the TEI number in the Manual TEI field or
select the Assign Automatic TEI check box. (When
this value is changed, the card reboots itself and all
current calls on the card are lost.)