218 CHAPTER 3: DEVICE CONFIGURATION
3Scroll through the Member List to verify that all eight channels are
present.
4To transfer a channel from the non-member list to the member list, select
the channel and click <<.
You cannot transfer a channel from the Member List to the Non-Member
list.
Completing the BRI-ST Configuration
To complete the BRI-ST installation:
1Return to the Digital Line Cards tab.
2From the Select Device Type list, select ISDN BRI Channel List.
3Click Apply.
4Wait approximately 30 seconds for the status of each channel to change
from Ready to Idle.
If the channel status does not change to Idle, verify that you have enabled
the On Line check box for the card, the span, and the group.
While you are waiting, click Apply to refresh the list of channels and to
see the updated status.
BRI-ST Card Status
Lights
Each of the four spans on a BRI-ST card has status lights that indicate the
status of the span (Tab le 42).
Table42 BRI-ST Card Status Lights
Status DB1 B2
Off No Layer 1 connection is
established with the Central
Office (CO).
The channel is not
carrying a call. The channel is not
carrying a call.
Yellow A Layer 1 connection is
established but the channel
is not yet ready to make or
receive calls.
A call build-up is
occurring. A call build-up is
occurring.
Green The channel is ready to make
and receive calls. A call is connected. A call is connected.