Acer DT85 manual Adding or replacing memory modules, To add or replace memory modules

www.packardbell.com

Adding or replacing memory modules

Important

Use only memory modules designed for this Packard Bell notebook.

Tools you need to complete this task:

Flat-blade driver - OR - Scribe or non-marring tool

Phillips #0 screwdriver

To add or replace memory modules:

1Complete the steps in “Preparing the notebook” on page 51.

2Complete the steps in “Removing the bay cover” on page 55.

3If you are replacing a memory module, go to step 4.

If you installing an additional memory module, go to step 5.

4Use a non-marring plastic scribe to push out the latches on both sides of the memory slot until the module tilts upward. Then remove from the memory slot.

5Insert the new memory module at a 30° angle into an empty memory slot, and then press it down until it clicks into place.

The module is keyed so it can only be inserted in one direction. If the module does not fit, make sure that the notch in the module lines up with the tab in the memory slot.

6Replace the bay cover, then tighten the cover screws.

57