
CHAPTER 3: Replacing notebook components
Replacing the touchpad board
Tools you need to complete this task:
- OR - | Scribe or |
Phillips #0 screwdriver
Screws removed during this task:
• 2 black M2.5×8 (LCD panel hinges - bottom)
• 2 black M2.5×8 (LCD panel hinges - top)
• | 13 black M2.5×8 (palm rest |
-base side)
• 3 black M2.5×8 (palm rest - top side)
To replace the touchpad board:
1Complete the steps in “Preparing the notebook” on page 51.
2If the notebook has a wireless card installed, follow step 1 to step 4 in “Replacing the wireless card” on page 58.
3Remove the keyboard by following the instructions in “Replacing the keyboard” on page 77 .
4Remove the keyboard cover by following the instructions in “Replacing the keyboard cover” on page 79.
5Remove the LCD panel assembly by following the instructions in “Replacing the LCD panel assembly” on page 83.
6Remove the palm rest by following the instructions in “Replacing the palm rest” on page 87.
7Turn the palm rest over so that its underside is facing up.
8Disconnect the touchpad board cable.
90