Agilent Technologies B2201A, B2200A manual ROUTeAGNDPORT

SCPI Command Reference [:ROUTe]:AGND:PORT

	[:ROUTe]:AGND:PORT
	This command specifies the input Ground Port for the specified card. For each card,
	you can specify the same or different Ground Port. At *RST, the Ground Port is 12.
	The ground mode is set by “[:ROUTe]:AGND[:STATe]”.
	The query returns the input port number of the Ground Port.
	The input ground port and a ground enabled input port cannot be assigned to the
NOTE
	same input port.
	If the input ground port and a couple port have been assigned to the same input port,
	the ground mode and the couple mode cannot be used in parallel.
	0 V output voltage source should be connected to the input Ground Port. Or set
	ground_port to 12, and open the input port 12 that is the default ground port. If you
	assign the input 12 as the ground port, this ground port will be internally connected
	to the ground when the ground mode is set to ON.
Syntax	[:ROUTe]:AGND:PORT card_number,ground_port
	[:ROUTe]:AGND:PORT? card_number
	Parameter	Explanation
	card_number	For Auto Config mode: 0 or ALL
		For Normal Config mode: 1, 2, 3, 4, or ALL
		ALL is not available for query.
	ground_port	Input port number: 1 to 14. Or -1to disable ground
		port.
Query response	port_number <newline><^END>
	port_number = 1 to 14 or -1. Number set to ground_port.
Example	OUTPUT @Agb2200;":ROUT:AGND:PORT 0,13"
	OUTPUT @Agb2200;":ROUT:AGND:PORT? 0"
	ENTER @Agb2200;A

In this example, A will be 13.

Agilent B2200 User’s Guide, Edition 2 5-27