Agilent Technologies B2201A, B2200A manual C2L, Compensation Explanation Coefficients

						Programming
					Capacitance Compensation
Table 4-10	Compensation Coefficients and Modifications
	Compensation			Modifications of data file
	coefficients
		C2H	For the Agilent B2220A probe card interface, do not modify
		C2L	the lines.
			For the connector plate, change the R, L, C values in the lines.
			The value must be changed to the R, L, C values of the C2x
			path (triaxial cable with connector plate) shown in Figure 4-6.
		C3H	Change the R, L, C values in the lines. The value must be
		C3L	changed to the R, L, C values of the C3x path.
			For the Agilent B2220A probe card interface, probe card will
			be used for the C3x path.
			For the connector plate, coaxial cable with positioner will be
			used for the C3x path.
	2. Measure the R, L, C values of the C2x or C3x path by using the Agilent 4284A.
		See “To obtain compensation coefficients” on page 4-26.
		After the measurements, calculate the per meter value of the R, L, C, and record
		them into the following table.
		Compensation			Explanation
		coefficients		R (Ω)	L (H)	C (F)
		C2H
		C2L
		C3H
		C3L

3.Open the template file selected at step 1 by using a text editor. Exchange the R, L, C values of C2x/C3x with the values recorded at step 2. And save the file as your compensation data file (e.g. C:\temp\my_env_1.txt).

Do not change any other lines. Also do not change the value for the coefficients that should not be modified.

Agilent B2200 User’s Guide, Edition 2 4-25