NOTE

CAUTION

Syntax

Query response

Example

SCPI Command Reference [:ROUTe]:AGND:UNUSED

[:ROUTe]:AGND:UNUSED

This command specifies the ground-enabledinput ports for the specified card. When the Ground Mode is ON, the ground-enabledinput ports that have not been connected to any other port are connected to the input Ground Port. At *RST, no input port is ground-enabled. The ground mode is set by “[:ROUTe]:AGND[:STATe]”.

The query returns which input ports are ground-enabled.

The input ground port and a ground enabled input port cannot be assigned to the same input port.

If the ground enabled input port and a couple port have been assigned to the same input port, the ground mode and the couple mode cannot be used in parallel.

Open the input ports set to this command. If any equipment is connected to the ground-enabledinput ports, turning the Ground Mode ON may cause damage in the equipment.

[:ROUTe]:AGND:UNUSED card_number,'port_number'

[:ROUTe]:AGND:UNUSED? card_number

Parameter

Explanation

 

 

card_number

For Auto Config mode: 0 or ALL

 

For Normal Config mode: 1, 2, 3, 4, or ALL

 

ALL is not available for query.

port_number

Input port number: 1 to 8.

 

Enclose by single quotation marks. Separate multiple

 

input port numbers by comma. For example: '1,5'

port_number{, port_number} <newline><^END> port_number = 1 to 8

OUTPUT @Agb2200;":ROUT:AGND:UNUSED 0,'5,6,7,8'"

OUTPUT @Agb2200;":ROUT:AGND:UNUSED? 0"

ENTER @Agb2200;A$

In this example, A$ will be 5,6,7,8.

Agilent B2200 User’s Guide, Edition 2

5-29

Page 155
Image 155
Agilent Technologies B2201A, B2200A manual ROUTeAGNDUNUSED