Important Safety Instructions
Your OKIDATA printer has been carefully designed to give you years of safe, reliable performance. As with all electrical equipment, however, there are a few basic precautions you should take to avoid hurting yourself or damaging the printer:
•Read the setup and operating instructions in this handbook carefully. Be sure to save it for future reference.
•Read and follow all warning and instruction labels on the printer itself.
•Unplug the printer before you clean it. Use only a damp cloth; do not use liquid or aerosol cleaners.
•Place your printer on a firm, solid surface. If you put it on something unsteady, it may fall and be damaged; if you place it on a soft surface, such as a rug, sofa, or cushioned surface, the vents may be blocked, causing the printer to overheat.
•To protect your printer from overheating, make sure all openings on the printer are not blocked. Don’t put the printer on or near a heat source, such as a radiator or heat register. If you put it in any kind of enclosure, make sure it is well ventilated.
•Do not use your printer near water, or spill liquid of any kind into it. Be certain that your power source matches the rating listed on the back of the printer. If you’re not sure, check with your dealer or with your local power company.
•Your printer has a grounded,
•The printer must be installed near a power outlet which remains easily accessible.
•To avoid damaging the power cord, don’t put anything on it or place it where it will be walked on. If the cord becomes damaged or frayed, replace it immediately.
•If you’re using an extension cord or power strip with the printer, make sure that the total of the amperes required by all the equipment on the extension is less than the extension’s rating. The total ratings of all equipment plugged into the outlet should not exceed 15 amperes.
•Do not poke anything into the ventilation slots on the printer; you could get an electrical shock or cause hazardous electrical arcing.
•Aside from the routine maintenance described in this handbook, don’t try to service the printer yourself; opening the cover may expose you to shocks or other hazards. Don’t make any adjustments other than those outlined in the
•If anything happens that indicates that your printer is not working properly or has been damaged, unplug it immediately and follow the procedures in Appendix A for having your printer serviced. These are some of the things to look for:
-The power cord or plug is frayed or damaged.
-Liquid has been spilled into the printer, or it has been exposed to water.
-The printer has been dropped, or the cabinet is damaged.
-The printer doesn’t function normally when you’re following the operating instructions.
