DUP ADJ

0mm (Range +2.00 to –2.00 mm, in 0.25 mm intervals)

Notes: For the OKIPAGE 20, this setting only applies when the optional Duplex Feeder is installed.

Adjust vertical print position in 0.25

mmincrements. Plus (+) indicates downward movement, minus (–) indicates upward movement.

In PostScript mode, any negative values selected will be ignored.

2ND TRAY

5 (Range 1 to 16)

Notes: Applies only when the optional Paper Expansion Tray is installed. Sets the priority of the optional tray in the HP PCL 6 emulation.

3RD TRAY

9 (Range 1 to 16)

Notes: Applies only when two optional Paper Expansion Trays are installed. Sets the priority of the second optional tray in the HP PCL 6 emulation.

FRONT

4 (Range 1 to 16)

Notes: Sets the priority of the Manual Feeder in the in the HP PCL 6 emulation.

PLACE PG

CENTER

LEFT

Notes: Sets placement of printed image on the page.

SETTING

0 (Range –1 to +1 in increments of 1)

Notes: Adjust to improve print quality:

–2 Rough/thick papers and/or low temperature/humidity

–1

0Normal media/environmental conditions

+1

+2 Rough papers and/or high tem- perature/humidity

CLN CYCL

NORMAL

MIDDLE

HIGH

Notes: Sets the frequency of the page cleaning sequence:

NORMAL = every 20 pages MIDDLE = every 10 pages HIGH = every 3 pages.

Chapter 3: The Printer Menus

E–25

Page 33
Image 33
ALFA 20DX manual Dup Adj