Allied Telesis AT-IX5-28GPX Installing the Switch in an Equipment Rack, Removing the Rubber Feet

IX5-28GPX Installation Guide

Installing the Switch in an Equipment Rack

This procedure requires the following items:

ˆTwelve bracket screws (included with the switch)

ˆTwo equipment rack brackets (included with the switch)

ˆFlat-head screwdriver (not provided)

ˆCross-head screwdriver (not provided)

ˆFour standard equipment rack screws (not provided)

Installation guidelines may be found in “Choosing a Site for the Switches” on page 56. Here is the procedure for installing the switch horizontally or vertically in a 19-inch equipment rack.

Caution

The chassis may be heavy and awkward to lift. Allied Telesis recommends that you get assistance when mounting the chassis in an equipment rack.  E28

1. Place the unit upside down on a level, secure surface.

COL HDX FDX ACT LINK 10/100 ACT LINK 1000

	S2/28	26
CONSOLE
	S1/27 SFP+	25

IX5-28GPX

2668

Figure 23. Turning the Switch Upside Down

2.Using a flat-head screwdriver, pry the rubber feet from the bottom of the switch, as shown in Figure 24.

2

1

IX5-28GPX

2669

Figure 24. Removing the Rubber Feet

67