Chapter 4: Installing the Switch and its Power Supplies
Installing the Power Cord Retaining Clip
This section applies to AC power supply modules.
Perform the following procedure to install the power cord retaining clip on each power supply module:
1. Locate the power cord retaining clip, shown in Figure 17.
Figure 17. Power Cord Retaining Clip
2.Install the clip on the AC power connector on the power supply module. With the ‘u’ of the clip facing down, press the sides of the clip toward the center and insert the short ends into the holes in the retaining bracket, as shown in Figure 18.
100- |
|
240VAC | ~ |
|
Figure 18. Inserting the Retaining Clip into the Retaining Bracket
You are now ready to install the switches, as explained in the next procedures.
62
