Chapter 4: Installing the Switch and its Power Supplies
Connecting AC Power to a Power Supply Module
To power on a switch with one or two AC Power Supply Modules, perform the following procedure:
1.Position the power cord retaining clip in the up position, as shown in Figure 28.
~ | ||
C | ||
|
Figure 28. Power Cord Retaining Clip in the Up Position
2.Plug the power cord into the AC power connector on the rear panel of the unit, as shown in Figure 29. Lower the power cord retaining clip to secure the power cord to the unit.
Warning: Power cord is used as a disconnection device. To de- energize equipment, disconnect the power cord. E3
100- |
|
240VAC | ~ |
|
Figure 29. Connecting the AC Power Cord
70
