Allied Telesis AT-IX5-28GPX manual Figures

Figures

Figure 1: Front Panel of the AT-IX5-28GPX Switch	19
Figure 2: Back Panel of the Switch	19
Figure 3: AT-IX5-28GPX Management Panel	20
Figure 4: LEDs for the 10/100/1000Base-T Ports	31
Figure 5: SFP+ Slot LEDs	32
Figure 6: Switch ID LED	34
Figure 7: Switch ID LED	34
Figure 8: Switch ID LEDs in the Low Power Mode	35
Figure 9: AT-PWR800 Power Supply	38
Figure 10: Stacking Transceivers	42
Figure 11: Stack of Two Switches in the Linear Topology	44
Figure 12: Stack of Four Switches in the Linear Topology	45
Figure 13: Stack of Two Switches in the Ring Topology	46
Figure 14: Stack of Four Switches in the Ring Topology	47
Figure 15: PORT Parameter in the Command Line Interface	50
Figure 16: Components of the switch	59
Figure 17: Power Cord Retaining Clip	62
Figure 18: Inserting the Retaining Clip into the Retaining Bracket	62
Figure 19: Removing the rear panel	63
Figure 20: Installing the AT-PWR800 Power Supply Module	64
Figure 21: Securing the AT-PWR800 Power Supply Module	65
Figure 22: Installing the Blank Panel on the Power Supply Slot	65
Figure 23: Turning the Switch Upside Down	67
Figure 24: Removing the Rubber Feet	67
Figure 25: Attaching the Equipment Rack Brackets	68
Figure 26: Mounting the Switch Horizontally in an Equipment Rack	69
Figure 27: Mounting the Switch Vertically in an Equipment Rack	69
Figure 28: Power Cord Retaining Clip in the Up Position	70
Figure 29: Connecting the AC Power Cord	70
Figure 30: Connecting the Management Cable to the Console Port	72
Figure 31: Switch Initialization Messages	74
Figure 32: Switch Initialization Messages (Continued)	74
Figure 33: Switch Initialization Messages (Continued)	75
Figure 34: User Exec Mode Prompt	78
Figure 35: SHOW STACK Command	79
Figure 36: Moving to the Global Configuration Mode	79
Figure 37: Confirmation Prompt for the NO STACK ENABLE Command	80
Figure 38: Returning to the Privileged Exec Mode	80
Figure 39: Saving the Changes with the WRITE Command	80
Figure 40: Status of a Stacking Slot When VCStack is Disabled	81
Figure 41: Status of a Stacking Slot When VCStack is Enabled	82
Figure 42: PORT Parameter in the Command Line Interface	83
Figure 43: User Exec Mode Prompt	87
Figure 44: Moving to the Privileged Exec Mode with the ENABLE Command	87
Figure 45: Moving to the Global Configuration Mode with the CONFIGURE TERMINAL Command	88
Figure 46: Activating VCStack with the STACK ENABLE Command	88
Figure 47: Returning to the Privileged Exec Mode with the EXIT Command	88
Figure 48: Saving the Change with the WRITE Command	88
Figure 49: Rebooting the Switch with the REBOOT Command	89

7