Chapter 4: Installing the Switch and its Power Supplies
Starting a Local Management Session
This procedure requires a terminal or a terminal emulator program and the management cable that comes with the switch. To start a local management session on the switch, perform the following procedure:
1.Connect the
2 | 5 |
SFP |
|
|
+ | S1 | /27 |
| ||
|
|
2 | 6 |
S2 | LE |
2680
Figure 30. Connecting the Management Cable to the Console Port
2.Connect the other end of the cable to an RS-232 port on a terminal or PC with a terminal emulator program.
3.Configure the terminal or terminal emulator program as follows:
Baud rate: 9600 bps (The baud rate of the Console Port is adjustable from 1200 to 115200 bps. The default is 9600 bps.)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.
4. If you have not already done so, power up the switch as described in the previous procedures.
72
