Chapter 2. CLI Syntax Reference
/cx/ux show qpolicy
This feature only applies to 9550SX and 9590SE model controllers.
This command reports the queue policy of the firmware. If the queue policy is on, the firmware utilizes the drive queueing policy. If some drives in the unit do not support a queueing policy, this policy will have no effect on those drives.
Note that currently only NCQ will be enabled, not
Example:
//localhost> /c0/u5 show qpolicy /c0/u5 Command Queuing Policy = on
/cx/ux show storsave
This feature only applies to 9550SX and 9590SE model controllers. This command reports the storsave policy on the unit.
For more information see, “/cx/ux set storsave=protectbalanceperform [quiet]” on page 63.
Example:
//localhost> /c0/u5 show storsave /c0/u5 Command Storsave Policy = protect
/cx/ux show identify
This feature only applies to 9550SX and 9590SE model controllers.
This command is related to the /cx/ux set identify command. It shows the identify status of the specified unit (either on or off).
Example:
//localhost> /c0/u0 show identify /c0/u0 Identify status = on
/cx/ux show autoverify
This feature only applies to 9000 series controllers.
This command shows the current autoverify setting of the specified unit.
Example:
//localhost> /c0/u0 show autoverify /c0/u0 Auto Verify Policy = off
56 | 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5 |
