Port Object Commands
Port Object Commands
Port Object Messages are commands that provide information and perform actions related to a specific disk, attached to a port, such as /c0/p0. You use port object commands for such tasks as seeing the status, model, or serial number of the drive.
Syntax
/cx/px show
/cx/px show attribute [attribute ...] where attributes are: capacityfirmwareidentify (9550SX and 9590SE only) lspeed (9550SX and 9590SE only)model
ncq (9550SX and 9590SE only)serialsmartstatus /cx/px show all
/cx/px remove [noscan][quiet]
/cx/px set identify=onoff (9550SX and 9590SE only)
/cx/px show
This command shows summary information about the specified disk attached to port /cx/px. Typical information looks like:
Example:
//localhost> /c1/p5 show
Port Status Unit Size Blocks Serial
p5 | OK | u0 | 149.05 GB 312581808 | 3JS0L9QW |
The above report indicates that port 5 of controller 1 is attached to one l disk with status OK participating in unit 0.
/cx/px show attribute [attribute ...]
This command shows the current setting of the given attributes on the specified port or drive. One or many attributes can be requested. Specifying an invalid attribute will terminate the loop. Possible attributes are: capacity, firmware, identify (9550SX and 9590SE only), lspeed (9550SX and 9590SE only), model, ncq (9550SX and 9590SE only), serial, smart, and status.
www.3ware.com | 69 |
