AMCC 9590SE-4ME manual cx/ux remove noscan quiet, cx/ux del noscan quiet

Chapter 2. CLI Syntax Reference

u1-2	DISK	OK	-	-	p2	-	298.20
u1-3	DISK	OK	-	-	p3	-	298.20
u1-4	DISK	OK	-	-	p4	-	298.20
u1-5	DISK	OK	-	-	p5	-	298.20
u1-6	DISK	OK	-	-	p6	-	298.20
u1-7	DISK	OK	-	-	p7	-	298.20
u1-8	DISK	OK	-	-	p8	-	298.20
u1-9	DISK	OK	-	-	p9	-	298.20
u1-10	DISK	OK	-	-	p10	-	298.20
u1-11	DISK	OK	-	-	p11	-	298.20
u1/v0	VOLUME	-	-	-	-	-	500.00
u1/v1	VOLUME	-	-	-	-	-	3078.40

/cx/ux remove [noscan] [quiet]

This command allows you to remove (or export) a unit. Exporting a unit instructs the firmware to remove the specified unit from its poll of managed units, but retains the DCB (Disk Configuration Block) metadata. As such the unit can later be re-imported.

noscan is used to not inform the operating system of this change. The default is to inform the operating system.

quiet is used for non-interactive mode. No confirmation is given and the command is executed immediately. This is useful for scripting purposes.

Example of interactive mode: //localhost> /c0/u0 export

Are you sure you want to export or remove the unit /c0/u0? Enter Y to continue.

Note: After the unit is removed through the CLI, the unit can be physically removed. Hot swap carriers are required to do this while the system is online. Otherwise you must power down the system to prevent system hangs and damage.

/cx/ux del [noscan] [quiet]

This command allows you to delete a unit. Deleting a unit not only removes the specified unit from the controller's list of managed units, but also destroys the DCB (Disk Configuration Block) metadata. After deleting a unit, ports (or disks) associated with the unit will be part of the free pool of managed disks.

Warning: This is a destructive command and should be used with care. All data on the specified unit will be lost after executing this command.

58 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5