5Passing the external connector through the hole in the vertical plate, insert the card into the communication slot. Press down on the card until the connector is solidly in place.
Don’t force the card. If you meet resistance, pull it out and try again. If your card has a hook, make sure the hook engages the vertical plate.
6To see if the card is properly connected, lift it gently. If it resists and stays in place, it’s connected.
Note: After you have finished these installation instructions and turned on your computer, you may need to install software for your communication card. If you installed an Ethernet card, you may also need to change the network connection in the AppleTalk control panel. See the manual that came with the card and “Connecting to an Ethernet Network” in the section, “Connecting to a Network” in Chapter 3 for more information.
7If you have DIMMs or a High Performance Module to install, go to the next section in this chapter. If you are finished installing items in your computer, proceed to “Closing the Computer.”
144 | Chapter 8 |
