AT&T 585-300-903 10-4DCP Mode 1 Installation and Administration, Dial Access CODE/TRUNK ID Code

10-4DCP Mode 1 Installation and Administration

________________________________________________________________________________________________

________________________________________________________________________________________________

Generic 2 Administration

The following Manager II translations need to be completed for a Generic 2 for static switched 56 Kbps networking. For Generic 2 translations using dynamic 56 Kbps networking, contact the BCSDC.

NOTE

DEFINITY Manager III and Manager IV are covered in their own documentation sets. Refer to the list of documents in Chapter 9 to find the appropriate manual for administering systems using Manager III or Manager IV.

1.Using Procedure 100, Word 1, make the assignments shown in Fields 1 through 9. The trunk group (76) and the dial access code/trunk ID code shown are only examples; enter the appropriate values supplied by the BCSDC.

NOTE

To administer members of the trunk group, use Procedure 116.

If you need to change the signaling type, use Procedure 100, Word 3.

ENHANCED MODE - PROCEDURE: 100, WORD: 1

TRUNK GROUP TRANSLATION

1. Trunk Group: 76

DIAL ACCESS CODE/TRUNK ID CODE

2.Digit 1: 7

3.Digit 2: 5

4.Digit 3: 1

5.Digit 4: -

6.Trunk Type: 41

7.Dial Access Restriction: 0 Access is allowed using DAC

8.Personal CO Line Appearance: 0 Not used for CO line appearance

9.Public Network Access/Egress: 1 Enabled

DISPLAY ONLY

10. Signaling Type: 26 E&M wink/delay dial out with fail on timeout

Connected to CC0 ON-LINE ♥

MAJOR

MINOR

RUN TAPE

BUSY OUT

IN USE

WAIT

enter command: _

2 Repeat 3 Form

5 Help 6 Field 7 Input 8 Cmds

Figure 10-1.Manager II Mode 1 Administration (Proc 100, Word 1)