AT&T 585-300-903 manual Non-DCP Switch Applications, 2DCP Cabling and Administration

9-2DCP Cabling and Administration

________________________________________________________________________________________________
________________________________________________________________________________________________
25-PAIR MALE
CONNECTOR
		SWITCH
	DCP	DCP
AUDIX		PORTS
	RS-232C	ED-1E434-11
ACC (OR ACCE)		GROUP 300
25-PAIR FEMALE	A	(OR GROUP 500)
CONNECTOR	RS-232C
		CROSS-CONNECT
	B	FIELD
H600-331, GROUP 2
AUDIX NETWORKING
BREAKOUT CABLE

Figure 9-1.DCP Cabling to the Switch Using the H600-331, Group 2 Cable

Non-DCP Switch Applications

The AUDIX DCP channels are connected directly to the MERLIN II using D8W-87 modular cords. The installation of the MERLIN II Communications System is the responsibility of the customer or AT&T General Business Systems. Thus, the following procedure requires a coordinated effort between them and the AUDIX system installer. Make sure that the TN366B, TN539, or TN539B board is installed in the AUDIX system and that the AUDIX system and MERLIN II are operational.

1.Assemble the system modules as shown in Figure 9-2,MERLIN II Default Configuration and Slot Assignments, and power-on the MERLIN II system. The numbering of the jack positions will be the default numbering shown on the 008D modules in Figure 9-2.If additional 008D modules need to be added for additional ports, the numbering scheme continues to increase upward from bottom to top, left to right as shown.