AT&T 585-300-903 manual Testing Remote Switched RS-232 Converted to DCP Connections, Made

AUDIX Network Testing 14-11

_______________________________________________________________________________________

_

Step 1C: Testing Remote Switched RS-232 Converted to DCP Connections

This test involves a path similar to Figure 14-10,Remote Connection Test (RS-232 Converted to DCP).

1.Go to the system : translation : machine : audix/amis/call delivery form.

Set machine name to the name of the remote AUDIX system. Press ENTER . The remote AUDIX system’s machine profile should be displayed. If it is not displayed, it has not been assigned. Go to Chapter 13, AUDIX System Administration, and create the remote system profile.

2.The network connection channel (or channel) should be blank unless channel 5 or channel 6 must be used for the call (in which case, enter the channel number).

3.The network data phone number (or dial string) should be blank. Press changes were made.

CHANGE or RUN

if any

4.Go to the system : translation : network port form. Make sure the

switched/dedicated field for the channel(s) is set to s. Press CHANGE or RUN if any changes were

made.

5.Go to the maintenance : network form. Make sure the channel to be tested is idle.

6.Go to select test and enter 1.

7. Go to machine name and enter the name of the remote AUDIX system. Press CHANGE or RUN . Wait for the result. If the test is not successful, check the system : log and/or go to Flowcharts For Troubleshooting the Network.