AT&T 585-300-903 manual Generic 2 Administration, Manager III and Manager IV Administration

DCP Cabling and Administration 9-9

_______________________________________________________________________________________

_

Generic 2 Administration

Generic 2 can use both I-channels of the DCP port. This provides access to all four AUDIX DCP networking ports. The DCP circuits are assigned as Dual Port Data. This section describes how to administer AUDIX networking on a Generic 2 switch using the enhanced mode of Manager II.

Some general notes on Generic 2 requirements include:

∙Auxiliary tone pack: A Generic 2 with traditional modules must have at least one SN253C auxiliary tone pack in every traditional module; this pack is administered using Proc 252, Word 2. No administration is required for the TN748C tone pack in a Generic 2 universal module.

∙Tone detector pack (remote networking configurations): A Generic 2 with traditional modules requires an SN255 tone detector pack, or an SN255B pack in applications requiring modems that use 2100 Hz answer tone (such as the AT&T 2296, 2248, or 2224). Four tone detectors should be assigned on each SN255 board; the tone-detector trunk group is assigned in Proc 100, Word 1 as trunk type 100, and circuits are assigned to this trunk group in Proc 150.

The TN748C board in a Generic 2 universal module can use channels 4 and 8 for tone detection; up to two tone-detector circuits can be assigned on each board and placed in a tone-detector trunk group. The number of tone detector circuits needed depends on the data traffic characteristics of the switch.

∙Universal modules: If the switch is a Generic 2 with universal modules, make sure the AUDIX system has a TN366B, TN539, or TN539B ACC(E) board. Otherwise, you can only assign two of the four available DCP channels.

Manager III and Manager IV Administration

DEFINITY Manager III and Manager IV are covered in their own documentation sets. Refer to the appropriate manual for more information on administering systems using Manager III or Manager IV:

∙DEFINITY® Manager III Operations (585-222-701)

∙DEFINITY® Manager IV Facilities Management Operations (585-223-702)

∙DEFINITY® Manager IV Terminal Change Management Operations (585-223-701)

∙DEFINITY® Manager IV System Administration (585-223-700)