AT&T 585-300-903 manual Testing the Local Connection

AUDIX Network Testing 14-19

_______________________________________________________________________________________

_

Step 2B: Testing the Local Connection

This tests the loop shown in Figure 14-15,Local Connection Test (DCP), Figure 14-16,Local Connection Test (Switched RS-232), or Figure 14-17,Local Connection Test (Dedicated RS-232). In the case of RS-232 direct, you must first arrange the cabling as shown in the figure.

1.Go to the system : form and press ENTER

translation : machine : audix/amis/call delivery

. The local machine profile should be displayed.

2.Make sure the network data phone number (or dial string) includes only the extension number assigned to the networking hunt group. If using switched RS-232 channels with modems, the string must still start with ATDT. If using direct RS-232 channels, the dial string should be blank.

3.If the phone number had to be changed, go to the maintenance : audits : fp form and run a network data audit. This applies to R1V3 and R1V4 systems only; it is not necessary for R1V5 and later systems.

4.Go to the maintenance : network form. Set select test to 1. Press TAB .

Set machine name to the name of the local machine. Press CHANGE or RUN . Wait for the result. If the test is not successful, check the system : log and/or go to Flowcharts For Troubleshooting the Network.