AT&T 585-300-903 manual Extension Appearance ID

DCP Cabling and Administration 9-15

_______________________________________________________________________________________

_

6.Assign line appearances to the DCP equipment location. Make the entries as shown in Figure 9-9, Manager II Administration for DCP Ports (Proc 052, Word 1). The extension shown in Field 8 is only an example.

7.The first extension is assigned to Device Type 0 (Field 6) Member 0 (Field 7). Repeat step 6, only use Device Type 0 Member 1 and assign a different extension to it.

8.Repeat steps 6 and 7 for the second DCP equipment location. Assign two other extension numbers to Device Type 0 (Field 6) Members 0 and 1 (Field 7) for this equipment location.

If desired, you may display the extensions using Proc 052, Word 2.

ENHANCED MODE - PROCEDURE: 052, WORD: 1

		MULTIAPPEARANCE TERMINAL/DATA MODULE - LINE APPEARANCE
TERMINAL EQUIPMENT LOCATION			DEVICE ID
1.	Module:	0	6.	Device Type:	0 Basic Set
2.	Cabinet:	1	7.	Member (button):	0
3.	Carrier:	1	EXTENSION APPEARANCE ID
4.	Slot:	18	8.	Extension:	32330
5.	Circuit:	3	9.	Line Appearance:	1

10.Line Type: 1 Prime line

11.Ringing Type: 1 Ringing

12.Home Terminal: 1 Yes

13.Originating Only: 0 No

14.SAC Group: 0 No

DISPLAY ONLY

15. Button Type: 1 Line appearance (052w1)

Connected to CC0 ON-LINE ♥

MAJOR

MINOR

RUN TAPE

BUSY OUT

IN USE

WAIT

enter command: _

3 Data

5 Help 6 Field 7 Input 8 Cmds

Figure 9-9.Manager II Administration for DCP Ports (Proc 052, Word 1)

9.After the extensions are assigned here, their BCCOS may be reset to 1. Go back to Procedure 000, Word 3 and check if the BCCOS is still 6. If not, reset it to 6 if necessary. Check each of the AUDIX networking extensions.