Axis Communications A1001 user manual Reader Feedback, Set Up Recurrences, Event Wiegand

AXIS A1001 Network Door Controller & AXIS Entry Manager

Alarm and Event Configuration

2.Enter a descriptive name and the information needed for a daily, weekly, monthly or yearly schedule.

3.Click OK.

To use the schedule in an action rule, select the schedule from the Schedule drop-down list in the Action Rule Setup page.

Set Up Recurrences

Recurrences are used to trigger action rules repeatedly, for example every 5 minutes or every hour.

To set up a recurrence:

1.Go to Setup > Additonal Controller Configuration > Events > Recurrences and click Add.

2.Enter a descriptive name and recurrence pattern.

3.Click OK.

To use the recurrence in an action rule, first select Time from the Trigger drop-down list in the Action Rule Setup page and then select the recurrence from the second drop-down list.

To modify or remove recurrences, select the recurrence in the Recurrences List and click Modify or Remove.

Reader Feedback

Readers use LEDs and beepers to send feedback messages to the user (the person accessing or trying to access the door). The door controller can trigger a number of feedback messages, some of which are preconfigured in the door controller and supported by most readers.

Readers have different LED behaviors, but typically they use different sequences of steady lights and flashing lights in red, green, and amber.

Readers can also use one-pitch beepers to send messages, using different sequences of short and long beeper signals.

The table below shows the events that are preconfigured in the door controller to trigger reader feedback and their typical reader feedback signals.

Event	Wiegand	Wiegand	OSDP	Beeper pattern	State
	dual LED	single LED
Idle	Off	Red	Red	Silent	Normal
RequirePIN	Flashing red/green	Flashing red/green	Flashing red/green	Two short beeps	PIN required
AccessGranted	Green	Green	Green	One short beep	Access granted
AccessDenied	Red	Red	Red	One long beep	Access denied

Feedback messages other than the above must be configured by a client such as an access management system, through the VAPIX® application programming interface, that supports this feature and use readers that can provide the required signals. For more information, see the user information supplied by the access management system developer and reader manufacturer.

39