Axis Communications A1001 user manual Connectors and Buttons, Interface, External Power Inputs

AXIS A1001 Network Door Controller & AXIS Entry Manager

Hardware Overview

Lock

Note

Green	Steady when not energized.
Red	Steady when energized.
Unlit	Floating.

•The Status LED can be configured to flash while an event is active.

•The Status LED can be configured to flash for identifying the unit. Go to Setup > Additional Controller Configuration > System Options > Maintenance .

Connectors and Buttons

For technical specifications, see page 54.

I/O Interface

Reader Data Connector

Two 6-pin terminal blocks supporting RS485 and Wiegand protocols for communication with the reader. For specifications, see page 58.

Reader I/O Connector

Two 6-pin terminal blocks for reader input and output. In addition to the 0 V DC reference point and power (DC output), the reader I/O connector provides the interface to:

•Digital input – For connecting, for example, reader tampering alarms.

•Digital output – For connecting, for example, reader beepers and reader LEDs. For specifications, see page 58.

Door Connector

Two 4-pin terminal blocks for connecting door monitoring devices and request to exit (REX) devices. For specifications, see page 59.

Auxiliary Connector

4-pin configurable I/O terminal block. Use with external devices, in combination with, for example tampering alarms, event triggering and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the auxiliary connector provides the interface to:

•Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example PIR sensors or glass break detectors.

•Digital output – For connecting external devices such as burglar alarms, sirens or lights. Connected devices can be activated by the VAPIX® application programming interface or by an action rule.

For specifications, see page 59.

External Power Inputs

NOTICE

The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’s instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .

Power Connector

2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output current limited to ≤5 A. For specifications, see page 59.

Network Connector

RJ45 Ethernet connector. Supports Power over Ethernet (PoE). For specifications, see page 60.

8