DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
IMPORTANT: This message reminds you to change the serial port configuration of the host terminal to match the new configuration changes made to the serial port on the host module. If they do not match, the DS71 will be unable to interpret the next command, and you will be unable to access any connected unit. If this happens, recycle power and reconfigure the unit. Make any necessary changes to the host device before answering "Save Changes Permanently?"
|
|
| If you have made necessary changes to the | ||||||
|
|
| host device, type "Y" for yes, followed by | ||||||
|
|
| <cr>. New configuration changes are stored | ||||||
|
|
| permanently in |
| |||||
| From the configuration menu, select #2, | ||||||||
|
|
| “Serial Port Configuration”, followed by | ||||||
|
|
| <cr>. The DS unit asks for the Host Device | ||||||
|
|
| number. |
|
|
|
|
| |
|
|
| Enter Host Device Number |
|
| ||||
|
|
| Selecting #1 will give the same results as the | ||||||
|
|
| DS71 in the previous section. Selecting 2 | ||||||
|
|
| will give the following table: |
|
| ||||
Module 1 Serial Port Configuration : |
|
|
|
|
|
| |||
Port | Device | Baud | Word | Stop | Parity | Xon/ | Xoff/ | Line | Drive |
| Name | Rate | Size | Bits |
| Xmit | Recv | DTR | RTS |
|
|
|
|
|
|
|
|
|
|
2 | Host MODEM | 57.6k | 8 | 1 | None | Off | Off | High | High |
Exit/Save.............1 | Set Parity...............5 |
|
|
|
|
| |||
Set Baud Rate.....2 | Set Xon/Xoff..........6 |
|
|
|
|
| |||
Set Word Size.....3 | RTS Line Driver...7 |
|
|
|
|
| |||
Set Stop Bits........4 | DTR Line Driver...8 |
|
|
|
|
| |||
Enter Request :
Select the corresponding number to configure baud rate, word size, stop bits, parity.
31
