Bay Technical Associates DS73, DS2-RPC, DS4-RPC owner manual Outlet 1, Outlet 2, Outlet 3, Outlet

DS-RPC OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

__________________________________________________________________________________________

RPC CONFIGURATION

The REBOOT n command will reboot or reset equipment attached to corresponding receptacle(s). When the command to REBOOT (n) is sent from the RPC > prompt, the DS-RPC powers “Off” corresponding outlet(s) for approximately 10 seconds, then powers them up in sequence. This command only works on outlets which were “On” prior to the reboot.

The DS-RPC configuration menu allows the user to:

(1)set or change a password,

(2)customize the outlet name(s) to identify equipment attached to the RPC,

(3)enable or disable confirmation,

(4)enable or disable status menu.

The password is disabled from the factory by making the password a carriage return. If a password (other than a carriage return) is set, the DS-RPC requires password entry before allowing the user to operate the RPC unit. The password feature is case sensitive.

From the DS-RPC’s configuration menu, the user can change any outlet name to outline a unique set-up. Default outlet names are

Outlet 1, Outlet 2, Outlet 3, Outlet 4.

From the status menu’s DS-RPC > prompt, type CONFIG. The following menu appears:

64