Panasonic KX-TVP200 installation manual Error Indications at System Startup

7.2 UTILITY COMMANDS

$ ELOG
DEVICE		ERROR	TIME
1.	CPU	MEM-GET	14-JUL 2:00 PM
2.	CLOCK		14-JUL 2:00 PM
3.	DISK	DATA R/W (xx:yyyy)	14-JUL 2:00 PM
4.	DSP*	SCAN	14-JUL 2:00 PM
5.	DSP*	FIFO	14-JUL 2:00 PM
6.	CPU	APPLICATION (x)	14-JUL 2:00 PM

* = port number (1-12)

Note

The following tables display and explain the errors that the system can identify. Table 7-2 Device Error Log Indications

	Indication		Meaning
CPU	MEM-GET	CPU board software memory acquisition error.
		CPU board is short of memory temporarily
		because of too much traffic.
CLOCK		Clock access error. Clock IC is out of order.
		Check the hardware.
DISK	DATA R/W (xx:yyyy)	HDD access error. If there is a sector that often
		causes errors, check the disk.
		xx :	IDE error code
		yyyy : read/write error sector number
DSP*	SCAN	DSP-SCAN error. DSP is out of order. Check the
		hardware.
DSP*	FIFO	DSP/FIFO error. During the system is handling
		calls, there was a temporary problem with the DSP
		and FIFO memory.
CPU	APPLICATION (x)	Application error. While the system is handling
		calls, temporary application error occurs.
		x: port number

* = port number (1-12)

Examples of a terminal display when errors are generated:

Table 7-3 Error Indications at System Startup

Indication	Meaning
ROM ERROR: Sum Error!!	ROM checksum error.
DISK ERROR: Initialize Error!!	HDD initialisation error.
DISK ERROR: No System!!	No system HDD present.
DISK ERROR: Program Load Error!!	Programme could not be loaded from system
	HDD.
DISK ERROR: Program Sum Error!!	Checksum error in programme loaded from
	system HDD.

152 Installation Manual