Panasonic KX-TVP200 installation manual DPT None-Both PBX and VPS work independently

B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS

Table B-41

Parameter	Value Range	Description/Function
	(Default)
Integration	1. None	Specifies the method of integrating the VPS with the
Mode	2. Inband	PBX.
	3. DPT	1. None—Both PBX and VPS work independently,
	(None)
		without accessing information concerning the status
		of the other.
		2. Inband—The PBX sends touchtone codes to the
		VPS to indicate the state of the call (busy, answered,
		disconnect, etc.). Inband Integration improves the
		VPS performance because call state recognition is
		faster than with standard call progress tone
		detection. The PBX code for each call state must be
		set in the Inband Signaling Parameters. If PBX type
		is set to a KX-T series telephone system, the Inband
		Signaling Parameters will automatically default to
		the proper codes. This is available with any of the
		following Panasonic KX-T series telephone systems:
		TA series, T96, T336, TD816, TD1232, TD612 and
		TD500.
		3. DPT—The VPS communicates with the PBX via the
		DPT interface. This is available with any of the
		following Panasonic KX-TD series telephone
		systems: TD816, TD1232, TD612 and TD500.

To program the following 10 Parameters in the next table, use the Special Commands and Dial Codes listed below. You can set up to 12 digits for each parameter.

D:Disconnecting

F:Flash (Recall)

R:Ringback Tone Detection

S:Silence Detection

T:Dial Tone Detection

W:Wait for 1 s

X:Extension dialling

A:Answer

1-9, 0, , #: Dial Codes

Table B-42

Parameter	Value Range	Description/Function
	(Default)
Operator		The VPS performs this sequence when transferring calls
Transfer	(FX)	to the operator’s extension.
Sequence
Extension		The VPS performs this sequence when transferring calls
Transfer	(FX)	to any extension except the operator’s.
Sequence

268 Installation Manual