Panasonic KX-TVP200 Terminal Connection, Requirements for Connecting Programming Terminal

2.8 TERMINAL CONNECTION

2.8TERMINAL CONNECTION

2.8.1 Requirements for Connecting Programming Terminal

The programming terminal must be connected with a serial cable with an RS-232C connector at the RS-232C port. This must be a null modem cable. This enables system administration (system setup, mailbox setup, and system diagnosis) to be performed.

Communication parameters of the VPS have been set to the following values at the factory:

Table 2-5

COMMUNICATION PARAMETERS

Baud Rate:	9600 bps
Word Bit Length:	8	Bits
Parity:	None
Stop Bit Length:	1	Bit

2.8.2 Connecting the RS-232C Cable

RECOMMENDED:

Before connecting the cable, switch off the power on both the data terminal and the VPS.

RS-232C Cable

Data Terminal

Or Printer

RS-232C port

Insert the RS-232C cable into the VPS with the connector indicating the same direction.

The cable must be shielded and no longer than 2 m.

46

Installation Manual