Panasonic KX-TVP200 Unable to call Operator, Connected terminal RS, 232C port does not, Operate

7.4 TROUBLESHOOTING GUIDE

Table 7-5

PROBLEM	PROBABLE CAUSE	POSSIBLE SOLUTION
Unable to call Operator 1	• Improper setting of the	• Adjust the operator extension
	operator extension number.	number to that of the connected
		PBX (see "Operator’s
		Extension" in Table B-12in
		B5.1 Automated Attendant
		Parameters).
Connected terminal (RS-	• Improper connection.	• Be sure you are using a null
232C port) does not	• Improper setting of the RS-	modem cable (see 2.8
operate.	232C parameters.	TERMINAL CONNECTION).
		• The terminal and VPS should
		have the same parameter
		settings for Baud Rate, Word
		Bit Length, Parity and Stop Bit
		Length (see B7.1 RS-232C
		Parameters).
Unable to reconnect when	• Improper setting of the busy	• Re-adjust the busy signal
the line is busy.	signal reconnection procedure.	reconnection procedure to that
		of the connected PBX (see
		"Reconnect Sequence on
		Busy" in Table B-42in B7.3
		PBX Interface Parameters).
Unable to make a no-	• Improper setting of the no-	• Re-adjust the no-response
response reconnection.	response reconnection	reconnection procedure to that
	procedure.	of the connected PBX (see
		"Reconnect Sequence on No
		Answer" in Table B-42 B7.3
		PBX Interface Parameters).
Unable to generate a call	• Improper setting of sequence.	• Adjust the Call Waiting
waiting tone from the VPS.		sequence to that of the
		connected PBX (see "Call
		Waiting Sequence" in Table B-
		42 in B7.3 PBX Interface
		Parameters).
Unable to make Intercom	• Improper setting of the	• Adjust the Intercom Paging
Paging to groups.	Intercom Paging access code.	access code to that of the
		connected PBX (see "Paging
		Code for Group 1-16" and
		"Paging Code for All Groups" in
		Table B-34in B6.7 Other
		Parameters).

174 Installation Manual