Panasonic KX-TVP200 Inband Signaling Parameters, System Administration Top Menu-1-6-3-2

B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS

Table B-42

Parameter	Value Range	Description/Function
	(Default)
Alternate		The VPS performs this sequence when transferring calls
Extension	(FX)	to extensions in the Alternate Extension Group.
Transfer
Sequence
Reconnect		If an extension is busy, this sequence allows the VPS to
Sequence on	(FWW)	reconnect to the caller.
Busy
Reconnect		If the extension does not answer, this sequence allows the
Sequence on	(FWW)	VPS to reconnect with the caller.
No Answer
Reconnect		The VPS performs this sequence to retrieve a call placed
Sequence on	(FWW)	on hold after the extension (in the Call Screening mode)
Refuse Call		has refused to accept it.
Light-On		This is the dialling sequence that the VPS must perform to
Sequence for	(None)	enable the Message Waiting Lamp at an extension.
Message
Waiting Lamp
Light-Off		This is the dialling sequence that the VPS must perform to
Sequence for	(None)	disable the Message Waiting Lamp at an extension.
Message
Waiting Lamp
Call Waiting	(None)	The VPS carries out this sequence when performing call
Sequence		waiting if the extension being called is busy.
Release		The VPS performs this sequence to release call waiting.
Sequence for	(None)
Call Waiting

Inband Signaling Parameters

Use these parameters if the PBX sends touchtones to the VPS to indicate the state of a call (busy, answered, disconnected, etc.). The integration mode must be set to "Inband". If PBX type is set to a KX-T series telephone system, the Inband Signaling parameters will automatically default to the proper codes.

To access the proper menu for Inband Signaling Parameters, follow the menu path as shown:

System Administration Top Menu-1-6-3-2

The following parameters can be programmed using "0-9", "", "#", and "A-D".

Installation Manual 269