Panasonic KX-TVP200 installation manual Quick Setup Qset, Circuit Condition Display Lmon

7.2 UTILITY COMMANDS

$ HELP
OFLN	: System Off-line
ONLN	: System On-line
PASS	: Password setting
TIME	: Time & Date setting
PSET	: Report Print Out Time setting
ELOG	: Device Error Log Listing
SAVE	: VPS Program & Date Save (VPS —> PC : Xmodem)
LOAD	: VPS Program & Date Load (VPS <— PC : Xmodem)
GPRN	: Parameter Global Printing (only ‘ASCII Terminal’ mode)
VERS	: Program Version Check
CREP [no.]	: Custom Menu Information List
	[no.] : Custom Menu No. (1-100)
CCLR [no.]	: Custom Menu Access Counter Clear
	[no.] : Custom Menu No. (1-100/0) (0: Clear All)
MWL	: MWL Retry count Set (1-3)
MRL	: Minimum Recording Length Set (0-3)
MPLT [opt]	: Registered User Prompt No. List
	[opt] : 1	—> User Prompt 1
	2	—> User Prompt 2
	None —> User Prompt 1&2
QSET	: Quick Setup
LMON	: Line Monitor
PUTD	: DTMF Information Display (Don't leave enabled after
	troubleshooting.)
WCID	: Wait Time for Caller ID
$

7.2.17 Quick Setup (QSET)

Use the QSET command initially to perform a basic setup of your VPS when you use your VPS for the first time or after system initialisation.

Note

Quick setup requires VT100 emulation software.

Type QSET, then Press RETURN.

7.2.18 Circuit Condition Display (LMON)

Use the LMON command to display the circuit condition every 1.5 s. To turn off this command, enter [\].

The following circuit conditions may be displayed.

"Ready"	: Waiting for a call
"Incoming Call"	: Answering a call
"Outgoing Call"	: Making an outbound call
"DSP Reset"	: Processing DSP reset
"PT connect"	: Processing PT connect
"Error"	: DSP Card is not loaded

160 Installation Manual