Panasonic KX-TVP200 installation manual Table B-29 Parameter

B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS

Table B-29

Parameter	Value Range	Description/Function
	(Default)
Number of	0-8 digits	Specifies the number of digits necessary to access an
Digits	(1)	outside (CO) line.
to Access
Outside Line		Example:
		If the PBX requires callers to dial "9" to access an
		outside (CO) line, this parameter should be set as "1".
		This enables the system to recognise that an outgoing
		call setup sequence is completed once the initial "9"
		has been dialled (9-123-4567). The full sequence is
		therefore: 9-(outgoing call setup sequence)-123-4567.
		The VPS can discriminate between local and long
		distance calls and can report outgoing calls and calling
		times for billing purposes on periodic port usage
		reports.
Call Transfer	10-60 s	Specifies the length of time that the VPS must wait
No Answer	(20)	before retrieving the transferred call when there is no
Time		answer at the destination extension.
		Note: Make sure that the duration of Call Transfer No
		Answer Time is longer than the duration of Call
		Forwarding No Answer Time at the PBX. Otherwise,
		the PBX may forward the call (transferred by the VPS)
		immediately to its destination without leaving enough
		time to answer the call.
Outgoing Call	10-90 s	Specifies the length of time that the VPS must wait
No Answer	(30)	before concluding that there is no answer at the
Time		outside number called.
Pause Time	1-9 s	Specifies the pause time between dialled digits.
	(2)
Outgoing Call	Up to 12 digits	Specifies the sequence of codes used by the VPS
Setup	consisting of	when calling an outside (CO) line. You can set up to 12
Sequence	0-9, , #, F, R, S, T,	digits. The default value is "T". "T" indicates that the
	W	system will dial the telephone number only after
	(T)	detecting a dial tone.
		Example:
		9W = (9) - 2-s wait - dial telephone number. "9" is the
		outside (CO) line access number.

F: Flash (Recall)

R:Ringback Tone Detection

S:Silence Detection

T:Dial Tone Detection

W: Wait for 1 s

1-9, 0,, #: Dial Codes

256 Installation Manual