Panasonic KX-TVP200 Loading New or Saved Data to the VPS Load, Type LOAD, then Press Return

7.2 UTILITY COMMANDS

•If your data terminal supports a high speed, it is recommended that you SAVE at the maximum speed of 38400 bps. First, change the RS-232C setting of the VPS (see B7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminal to the same speed.

7.2.8Loading New or Saved Data to the VPS (LOAD)

Use the LOAD command to install new data or to restore saved data to the VPS. Execute this command for each data file.

When performing this operation, always wait until the process completion indication appears before proceeding.

1.Type LOAD, then Press RETURN.

$ LOAD

VPS Disk Data Load (PC -> VPS : Xmodem)

1:Program

2:Parameters

3:System Prompts

4. User Prompts-1

5. User Prompts-2

6. Custom Service Menus

7. Personal Greetings

8. Company Greetings Selection No.:

2.Select the item to be restored to the hard disk, then Press RETURN.

To start press 'RETURN'

3.Press RETURN.

-- - - - - Load Start!!

When "CCC" appears, the VPS is ready for loading.

4.Set the data terminal to the sending (Call) mode (Xmodem). Then enter the backup filename. Press ENTER. The backup data will be restored to the hard disk.

5.When the load to the VPS has been completed, power-off and restart the VPS.

Notes

•The data terminal that you use must be equipped with communications software that supports the Xmodem file transfer protocol. The command can be cancelled by Typing [\] before entering the sending mode. Once the sending mode has been selected, use the cancel command of the communication software being used.

•If your data terminal supports a high speed, it is recommended that you LOAD at the maximum speed of 38400 bps. First, change the RS-232C setting of the VPS (see B7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminal to the same speed.

Installation Manual 155