Panasonic KX-TVP200 installation manual Cause Remedy, Installation

4.3 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD612

10.Change the PBX type in the VPS programming menu in the following sequence.

•System prompts [>] are displayed on the screen. Press ENTER. Screen output:

Please Select Your Terminal Type.

1.ASCII TERMINAL

2.VT100

Please Enter the Number := ______

•Go to the PBX type selection menu,

By selecting your terminal type [1] or [2] and press ENTER,

Select [1] and press ENTER

Select [6] and press ENTER

Select [3] and press ENTER

Select [1] and press ENTER

Screen output:

Programm - Hardware Setting - PBX Interface Parameters - Dialing Parameters Menu PBX Type [Other]

1.Other Manufacturers 2. KXT series

•Select [2] (and press ENTER)

Enter the Model Number

1.T308 2. T616 3. T1232/TA series 4. T96 5. T336

6.TD816 7. TD1232/612 8. TD500 9. Reserved

•Select [7] (and press ENTER)

Escape the programming menu by entering Backslash Key until System prompt

[>] comes to be visible.

•Check the LED on the VPS unit. If the light is on, the DPT connection between VPS and PBX is established.

If the LED is flashing, the DPT connection cannot be established.

Possible causes of the message: "DPT Interface Connection is not Established"

Table 4-3

Cause	Remedy
The PBX is not a KX-TD series system. Since	Connect a KX-TD series PBX
the VPS is configured to communicate with the	and set the PBX type by using
KX-TD1232, this message will always appear	Quick Setup (see
when connecting to another type of PBX.	CUSTOMISING THE
	SYSTEM).
The cabling between the PBX extension ports	Confirm the cabling is
and the VPS is not 4-wire or is improperly	connected as described in
connected.	INSTALLATION.
The PBX is a KX-TD series but does not have	Consult your dealer
the proper level of software required to support	or use Inband Integration under
DPT Integration.	hardware settings.
The PBX is not programmed properly to support	Do required integration
DPT Integration.	programming as described in
	this chapter.

Installation Manual

89