Panasonic KX-TVP200 installation manual Cause Remedy, Customising, System

4.2 KX-TD500 PROGRAMMING FOR DIGITAL INTEGRATION

The calls to the VPS can be processed after the Power Indicator stops flashing.

After turning the power on, the system starts up in the following sequence:

•The Power Indicator light goes on.

•The Power Indicator light begins to flash.

•"CARD TEST" is displayed on the screen.

•"SYSTEM SETUP" is displayed.

Screen output:

...CARD TEST
SYSTEM SETUP...
1...	2...	3...	4...	5...	6...	7...	8...	9...	10...
11...	12...	13...	14...	15...	16...	17...

•The VPS tests the CPU board, the hard disk drive, and the CO cards as "SYSTEM SETUP..." is displayed.

•Active ports are displayed on the screen.

Screen output:

Active COs: 1 2 3 4 5 6 7 8 9 10 11 12 ** ON LINE MODE **

The display will alert you if System Setup is not completed successfully.

Screen output:

Active COs: 1 2 3 4 5 6 7 8 9 10 11 12 DPT Interface Connection is not Established ** OFF LINE MODE **

This message will appear when the DPT connection between the VPS and telephone system cannot be established.

Possible causes of the message: "DPT Interface Connection is not Established"

Table 4-2

Cause	Remedy
The PBX is not a KX-TD series system. Since	Connect a KX-TD series PBX
the VPS is configured to communicate with the	and set the PBX type by using
KX-TD1232, this message will always appear	Quick Setup (see Section 5
when connecting to another type of PBX.	CUSTOMISING THE
	SYSTEM).
The cabling between the PBX extension ports	Confirm the cabling is
and the VPS is not 4-wire or is improperly	connected as described in
connected.	Section 2 INSTALLATION.
The PBX is a KX-TD series but does not have	Consult your dealer
the proper level of software required to support	or use Inband Integration under
DPT Integration.	hardware settings.

Installation Manual

83