Panasonic KX-TVP200 installation manual Card Test System Setup

4.3 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD612

f)Repeat steps c, d, and e until all extension numbers are entered.

Conditions: No 2 jacks on the system can have the same extension number. If you try to enter a number that is already assigned, you will hear an error tone. Each digital extension connected provides 2 Voice Mail ports and must have 2 different extension numbers assigned.

6.Connect the jack assigned in Step 4 to the VPS.

7.Connect your personal computer to the VPS and start your communication software (i.e., HyperTerminal, Procomm Plus, Smartcom...).

Communication Parameters: 9600, 8 Bit, None, 1

8.Turn the power switch off at the VPS and set the Rotary Switch to position 5.

Only perform this step when initially setting up the system.

CAUTION

Setting the Rotary Switch to position 5 will default the Voice Processing System, resulting in a loss of all user programming and voice messages (except User 1 and User 2 prompts).

9.Turn the power switch back on at the VPS and wait approximately 7-8 min while the system initialises.

Before starting the VPS, make sure all installation and line connections have been done as described in Section 2 INSTALLATION.

The calls to the VPS can be processed after the Power Indicator stops flashing. After turning the power on, the system starts up in the following sequence:

•The Power Indicator light goes on.

•The Power Indicator light begins to flash.

•"CARD TEST" is displayed on the screen.

•"SYSTEM SETUP" is displayed.

Screen output:

...CARD TEST
SYSTEM SETUP...
1...	2...	3...	4...	5...	6...	7...	8...	9...	10...
11...	12...	13...	14...	15...	16...	17...

•The VPS tests the CPU board, the hard disk drive, and the CO cards as "SYSTEM SETUP..." is displayed.

•Active ports are displayed on the screen.

Screen output:

Active COs: 1 2 3 4 5 6 7 8 9 10 11 12 ** ON LINE MODE **

88

Installation Manual